Dymo LabelManager 220P Manuel d'utilisateur télécharger pdf (Page 6)

Connecting the Optional Power Adapter

An optional 9 Volt, 1.5 A power adapter can also be used to power the label maker.

Connecting the AC adapter disconnects the batteries as a power source.

To connect the power adapter

Plug the power adapter into the power connector on 1.

the top, left side of the label maker.

Plug the other end of the adapter into a power outlet. 2.

Ç Make sure the label maker power is turned o before

you disconnect the power adapter from the main power

source. Otherwise, your most recent memory settings

will be lost.

Inserting the Tape Cassette

Your label maker comes with one tape cassette.

You can purchase additional tape cassettes from

your local office supply retailer.

To insert the tape cassette

Lift the tape cassette cover to open the tape 1.

compartment. See Figure 3.

Ç Before using the label maker for the first

time, remove the protective cardboard insert

from the tape exit slot. See Figure 4.

Insert the cassette with the label facing up and 2.

the tape positioned between the guideposts.

Press firmly until the cassette clicks into place. 3.

See Figure 5.

Close the tape cassette cover. 4.

Guideposts

Figure 5

Click!

Remove

cardboard insert

Figure 4

Figure 3

Click!

LM220P-UK_WEU.indd 6 25-07-2007 14:45:11

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Pas de commentaire

Dymo LabelManager 220P Manuel d'utilisateur Page 6