Dymo Version 7.5 Guide de l'utilisateur télécharger pdf (Page 38)

Release 7.5 MADYMO Coupling Manual

7.3 Radioss Input Deck Setup

This section describes the required modiﬁcations to the Radioss input deck to perform Ex-

tended Coupling or Basic Coupling simulations. See the Radioss User Manual for details on

the cards not mentioned here speciﬁcally. Modiﬁcations to the MADYMO input deck are de-

scribed in Sec.

7.3.1 Basic Coupling

• Note that Radioss only uses the value of EXTERNAL_REF. However, the attribute EX-

TERNAL_DATA is mandatory in MADYMO and must therefore be given a value, be it

arbitrary.

• For Radioss, planes will be output in Radioss ANIMATION ﬁles, but no contact compu-

tation is possible with Radioss FE in Radioss.

• The interfaces TYPE 14 and 15 allow to compute contact between MADYMO hyper-

ellipsoids and Radioss FE. The option /MADYMO/LINK allows to connect a Radioss

node to a MADYMO body. (See the Radioss CRASH input manual for a description of

the options /MADYMO/LINK, /SURF/MDELLIPS, /INTER/TYPE14 and /INTER/-

TYPE15).

Input Example Basic Coupling

The following is part of a MADYMO input deck for Basic Coupling:

<COUPLING_SURFACE

EXTERNAL_REF="10"

SURFACE="/2/1"

EXTERNAL_DATA="0.0"/>

</COUPLING>

This will send data from surface /2/1 to Radioss. In Radioss one may refer to this data using

reference 10. Note the arbitrary value 0.0 for EXTERNAL_DATA, which is not used in Radioss.

The following is part of a Radioss STARTER input deck for Basic Coupling:

/SURF/MDELLIPS/1001/The first madymo coupl’d surface

Veriﬁcation

The user is advised to check the log ﬁle and the reprint ﬁle to verify if all entities are communi-

cated correctly. The log ﬁle shows the Radioss output of all entities received from MADYMO,

the reprint ﬁle shows the entities MADYMO sends to Radioss.

The Radioss STARTER log ﬁle:

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 62 63

Pas de commentaire

Dymo Version 7.5 Guide de l'utilisateur Page 38